Your cart is empty.
The 12 cell BMS measures 120mm x 80mm x 25mm and comes with balancing cables which measure 400mm in length. We also supply M3 bolts, nuts and ring terminals for attaching cables to BMS.
Why use a BMS with your battery cells?
The battery management system is designed to protect the cells which make up a battery pack and prolong the life of the battery. The BMS will monitor key operational parameters during the charging & discharging process such as voltages (upper & lower limits) and currents (maximum current limits) and will disconnect the battery from the load or charger should any of the set parameters be exceeded.
The BMS will also ensure that individual cells are balanced evenly, which is important due to the small differences between cells due to production tolerances.
We recommend that all LifePO4 cells are fully charged first with a single cell charger before assembling the battery pack & connecting the BMS.
Important - Due to the fact that we can't control how the BMS is installed this product does NOT come with a warranty. Please check the installation diagram carefully BEFORE attempting to connect the BMS to the battery pack. If you have no electrical experience we would recommend you consider purchasing a complete battery pack.
Balance voltage for single cell
Balance current for single cell
Current consumption for single cell
Maximum continuous discharge current
Maximum continuous charging current
3) Over Charge Protection
Over charge detection voltage
Over charge detection delay time
Over charge release voltage
Over discharge detection voltage
Over discharge detection delay time
Over discharge release voltage
Over current detection voltage
Over current detection current
Detection delay time
Exterior short circuit
Operating temperature range
Storage temperature range
There are currently no product reviews.